GE T1000 Technical Manual page 146

GE Reason Switches
146
Tacacs: authentication of this client will be done remotely
through a TACACS+ server;
No: authentication is disabled in this client and login is not
possible.


After one of the configurations described before is changed, there are two buttons
that allows the user to save or discard the configurations and to refresh the web
page.
Save: save configuration at the Running Config;
o
Reset: undo changes made locally at the Running Config.
o

SSH:
The SSH menu allows enabling the SSH protocol. The selection is made at the list at
the Mode row. Possible configurations are as follows.
Enabled: enable the SSH protocol usage as access and
o
configuration interface;
Disabled: disable the SSH protocol usage as access and
o
configuration interface.
After one of the configurations described before is changed, there are two buttons
that allow the user to save or discard the configurations and to refresh the web page.
Save: save configuration at the Running Config;
o
Reset: undo changes made locally at the Running Config.
o

HTTPS:
The HTTPS menu allows enabling the HTTPS protocol. When enabled, it is possible to
select if connections through HTTP protocol would be automatically redirected to
Cmd LvI: enable accounting of all commands of this client
with privilege level higher than the Cmd LvI value. That is,
this value will be the lowest Privilege Level required to do
accounting. Valid values are from 0 to 15;
Exec: enable exec (login) accounting at this interface.
Chapter 7 – Configuration
REASON SWITCHES-TM-EN-3