GE T1000 Technical Manual page 180

GE Reason Switches
180
If one configuration is desired to be applied at all ports, then the row "*" should be
used, that is, configuration done in the "*" row will be replied to all ports. Possible
configurations are as follows.
After one of the configurations described before is changed, there are buttons that
allow the user to save or discard the configurations.


VLAN Configuration:
o
This menu allows configuring VLAN based MLD Snooping. By default, no VLAN is
configured at the switch. If a new VLAN specific MLD entry is required, click at the
Add New MLD VLAN button. When clicked, it will appear the following fields to be
configured:






Throttling: indicates the maximum multicast
number groups allowed in the port. Possible
values are Unlimited and a range from 0 to 10.
Unlimited means that there is no limit for group
belonging in that port, and numbers shows
maximum multicast group numbers allowed.
Save: save configuration at the Running Config;
Reset: undo changes made locally at the Running Config.
Delete: click at the button to delete the VLAN entry at the
row;
LAN ID: specify the VLAN that is expected for receiving in
multicast frames from the address at this entry. Allowed
values are the VLAN allowed values (from 1 to 4,095);
Snooping Enabled: enable MLD Snooping function for this
entry. Checkbox selected means function enabled, and
checkbox empty means disabled;
Querier Election: enable VLAN at this entry to participate
of the querier election. If enabled, this VLAN entry can win
querier election and be selected as a path to the multicast
source to be used by multicast clients. Checkbox selected
means function enabled, and checkbox empty means
disabled;
Compatibility: indicates which MLD version this entry
should be compatible to. Allowed values are MLD-auto,
Forced MLDv1 and Forced MLDv2. By default, MLD-auto is
selected, which means switch will define itself protocol
running at the VLAN. Forced MLD values allow user to
configure explicitly which version entry should use;
Chapter 7 – Configuration
REASON SWITCHES-TM-EN-3