E Fn Iom Initial Out-Of-Box Configuration And Default Settings - Dell PowerEdge FX2 Deployment Manual

E FN IOM initial out-of-box configuration and default
settings
This section applies to the Dell PowerEdge FN I/O Module (FN IOM) in Standalone mode. Modules in
this section include the FN410S, FN410T, and FN2210S (applicable to ports in Ethernet mode only).
This section provides configuration examples for common upstream switches to establish a functional
uplink and bring up network ports on PowerEdge FC-Series servers (FC830, FC630, FC430, FC620
and FC420) in three easy steps:
1. Ensure the FN IOM is in Standalone Mode
2. Create an LACP LAG on the upstream top-of-rack (ToR) switch
3. Verify the connection
Note: This section covers basic configuration in a factory default standalone mode and is not
required for VLT configuration.
By default, the FN IOM is shipped from the factory in Standalone Mode, which consists of the following
default settings:
PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
100
Setting
Chassis Management Controller
Configuration
Stacking and VLT
Data Center Bridging Exchange Protocol
(DCBx)
FIP Snooping Bridge (FSB)
NPIV Proxy Gateway Mode (NPG)
iSCSI Optimization
Broadcast Storm Control
Internet Group Management Protocol
(IGMP) Flood Restrict
Network Time Protocol (NTP)
Enable and Disable ports
Uplink Failure Detection (UFD)
TACACS+/RADIUS (AAA Auth/Acct; Auth
coming up)
DHCP
Internet Group Management Protocol
(IGMP) v2 & v3
Default Value
Yes
Disabled
Enabled
Enabled on FN 410S and FN 410T
Disabled on FN 2210S
Enabled in FN 2210S
Disabled on FN 410S and FN 410T
Enabled
Enabled
Enabled
Enabled
All ports enabled by default.
Disable ports via Command Line
Interface
Enabled
Disabled
Enabled in client only mode
Enabled