8.1
Environment Three: FN IOM configuration
The configuration steps outlined below are repeated on both IOMs. When validating the configurations
in this guide the following management IP addresses (Table 9) were used.
Hostname
FN410S-A1
FN410S-A2
Note: If the IOMs have been previously configured, existing configuration settings will be retained
when changing IOM modes. Because of this, it is recommended that the IOMs be returned to factory
defaults before configuring. See the
instructions on setting an IOM back to factory defaults.
PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
52
Management IP address
IP Address
172.25.189.27
172.25.189.28
Reset FN IOM to Default Factory Configuration
Subnet
255.255.0.0
255.255.0.0
section for