FC630 Server
7.1
Environment Two: IOM Full Switch mode configuration
The configuration steps outlined below are repeated on both IOMs. When validating the configurations
in this guide the following management IP addresses (Table 6) were used.
Note: If the IOMs have been previously configured, existing configuration settings will be retained
when changing IOM modes. Because of this, it is recommended that the IOMs be returned to factory
defaults before configuring. See the
instructions on setting an IOM back to factory defaults.
PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
33
VLT Domain
mVLT configuration with a PowerEdge FX2, IOMs and S4810 switches
Management IP address
Hostname
FN410S-A1
FN410S-A2
FN410S-A1
VLTi
FN410S-A2
IP Address
172.25.189.27
172.25.189.28
Reset FN IOM to Default Factory Configuration
VLT Domain 2
S4810-1
VLTi
S4810-2
Subnet
255.255.0.0
255.255.0.0
section for