NEC Express5800 series User Manual page 76

CPU
To check the installed CPU status
Select [Main] - [Processor Settings] and check the status indications.
The on-screen CPU numbers and socket locations on the system board are shown in
the figure on the previous page.
To clear the CPU error information
Select [Main] - [Processor Settings] - [Processor Retest] - [Yes] and reboot the server.
Keyboard
To set Numlock
Select [Advanced] - [Numlock].
Security
To set passwords on the BIOS level
Select [Security] - [Set Administrator Password] and enter a password.
Set Administrator password first, then User password.
To enable/disable the POWER switch
Select [Security] - [Power Switch Inhibit] - [Enabled].
Select [Security] - [Power Switch Inhibit] - [Disabled].
IMPORTANT:
(see Chapter 6) as well as power on/off using the POWER switch.
To set the secure mode
Select [Security] - [Set User Password] and enter the password.
Select [Security] - [Secure Mode] and set each item.
External Devices
To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To set up internal PCI devices of the server
Select [Advanced] - [PCI Configuration] and set up each device.
To install the disk array controller
Select [Advanced] - [PCI Configuration] - [PCI Slot nx ROM] - [Enabled].
nx= Riser card number (n: 1 to 3) and type (x: C is low-profile type and B is
full-length/full-height type)
66 Setting Up Your Storage Server
Masking the POWER switch disables forced shutdown