NEC Express5800 series User Manual page 152

Inserting the Floppy Disk or CDROM Drive into the Flex Bay
The following explains the procedure for removing the hard disk drive and then installing the
floppy disk or CD-ROM drive in the bay:
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Unlock the front bezel with the security key and remove the front bezel.
3. Remove the hard disk drive.
4. Remove the spacer.
Insert the floppy disk or CD-ROM drive straight into the flex bay.
5.
6. Power on the server, start the SETUP utility, and make the following settings:
This operation is necessary because installing the floppy disk drive or CD-ROM drive
clears the current settings.
– Select [Boot] → [Boot Device Priority] → [ATAPI CD-ROM Drive] → [1st Boot
Drive].
– Select [Boot] → [Boot Device Priority] → [Removable Drive] → [2nd Boot
Device].
– Select [Boot] → [Hard Disk], and set the new boot priority.
Install the front bezel you removed in step 2.
7.
There are tabs on the left side of the front bezel. Engage the tabs with the server frame,
install the front bezel, and lock it with the security key.
142 Upgrading Your NEC Storage