NEC Express5800 series User Manual page 16

9-1 AC inlet (for the power supply unit provided as standard)
Connect the power cord to this socket when the power supply unit is mounted in power
supply slot 1.
9-2 AC inlet (for an additional power supply unit)
Connect the power cord to this socket when the power supply unit is mounted in power
supply slot 2.
10 Rear VGA connector. NOT USED ON A NAS SERVER.
Connect the monitor display unit to this connector.
11 SCSI connector
Connect external SCSI device to this connector.
12 POST lamps
They are when POST is running and checking the system.
13 Console Redirection switch
This switch enables the console redirection feature via serial port 2.
14 UID lamp (blue)
This lamp goes on when the UID switch is pressed or when a software command is issued.
15 STATUS lamp (green/amber)
This lamp indicates the server status. The lamp is green during normal operation. The lamp
turns amber colour or flashes when the server enters an abnormal state.
16 AC cord retainer
Bundle the AC cords.
17 AC POWER lamp
This lamp turns green and flashes when the server receives AC power from the power cord.
The lamp turns green when the server power switch is turned on, and it turns amber when a
power failure occurs.
18 LINK/ACT lamp (green)
This lamp indicates access status of the LAN.
19 LAN connectors
Connect LAN network systems to the connectors.
The number "1" following the bold-faced number indicates LAN port 1, and the number "2"
indicates LAN port 2.
20 Speed lamp (amber)
This lamp indicates the transmission speed of the LAN.
6 System Overview