NEC Express5800 series User Manual page 163

Install the components removed in steps 2 and 3.
6.
Power on the server and verify that POST displays no error messages.
7.
If POST displays an error message, take note of the message and see the POST error
messages listed in Chapter 6.
Start the SETUP and select [Advanced] → [Memory Configuration] to verify that the
8.
installed DIMM shows the status "Installed". (See Chapter 3 or details.)
Select "Yes" for [Reset Config Data] on the [Advanced] menu.
9.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
Your operating system is Windows 2000, set the paging file size to the recommended
10.
value or a greater value as shown below.
– For Windows 2000: Total memory size × 1.5
Upgrading Your NEC Storage 153