NEC Express5800 series User Manual page 162

DIMM Installation Procedure
Use the following procedure to install a DIMM.
IMPORTANT:
type (30 mm (1.2 inches) in height). It does not support DIMMs
exceeding the specified height.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
Pull out the server from the rack.
2.
Open the top cover.
3.
Remove the DIMM cover from the socket into which you are going to install a DIMM.
4.
Open the levers at both ends of the socket. The cover is released from the socket.
IMPORTANT:
Push the DIMM straight into the socket.
5.
NOTE: Make sure of the orientation of the DIMM.
Each DIMM has a slit on the terminal side for preventing wrong
insertion.
The levers automatically close when the DIMM is inserted into the socket.
152 Upgrading Your NEC Storage
The server supports DIMMs of only the low-profile
Save the removed DIMM cover for future use.
Key slot
Key
Key slot
Key