NEC Express5800 series User Manual page 64

FRONT
Device with the
SCSI interface
*1
USB device
REAR
Display unit
*1 Any USB keyboard and mouse are not supported.
*2 A leased line cannot be connected directly to this connector.
The console of a management PC can be connected to only serial port 2. (BIOS setting required) Connect the
console to only serial port 2 on either the front or rear panel. This connector is capped for preventing incorrect
connection in the standard status.
*3 Use the provided branch cable.
*4 Connect the power cord to a circuit breaker of 15 A or less.
NOTE:
Make sure of the cable you are going to connect. The LAN connector
and the serial port 2 connector of this server have the same shape. Be careful
not to connect a cable to a wrong connector. To prevent wrong connection, write
"LAN port" on a tag and put the tag to the connector of the LAN cable that is to
be connected to this server.
54 Setting Up Your Storage Server
Device with the
*2
serial interface
Keyboard
*3
Hub
USB device
(multiport repeater)
Display unit
Device with the
serial interface
Finally connect the
(e.g., Management
*3
provided power cord to
PC)
the receptacle.
If connecting the server
Mouse
to UPS, see the
explanation below.
Bundle the power
cord(s) with the
attached AC cord
holder.
If an optional power supply
unit is additionally installed,
connect the provided power
cord to this AC inlet and the
receptacle.
*1
*1
USB device
*4
*4