Arrow Keys - Challenge CHAMPION 370 XT Operator's Manual

8.8.10 Arrow Keys

The four arrow keys can be used in almost all screens. The arrow keys are primarily used for moving
the cursor around on the screen, or to toggle between highlighted selections. In some screens, the
left arrow key acts as a backspace key.
8.8.11 Contrast Control
The contrast of each display screen can be adjusted by using the contrast control buttons located
directly above each display screen.
8.9 Manual Backgauge Control
8.9.1 Backgauge Control Knob
The backgauge may also be controlled using the Backgauge Control Knob located at the front of the
table. Turning the knob clockwise brings the backgauge forward. Turning the knob counter-
clockwise sends the backgauge backward.
8.9.2 Backgauge Glide Control
The backgauge can be moved manually by use of the backgauge glide control. Press towards the
operator for forward travel and away from the operator for reverse travel. The further away from
center that the actuator is pushed, the faster the backgauge will travel.
8.9.3 Backlash Indicator
To insure accurate cuts, the backgauge must be brought to the cut position from the rear of the table.
In the display, to the right of the backgauge position, there is a small arrow to indicate reverse travel.
This arrow should be off when making a cut. Moving back past your cut position, then forward to it,
compensates for any play in the backgauge nut and lead-screw.
8.10 Send Mode
-------------------------------
C) Up
D) Down
Clamp
Pressure
| | | 14 | | |
5.070
in^
>_
Reverse
Indicator
E) Maint
F) Job H) Repeat
8.0 Operation
Arrow
27