Challenge CHAMPION 370 XT Operator's Manual page 16

4. Remove the rear arch cover assembly.
5. Insert the table from the rear of the machine, through the arch. The table is located using two
special taper pins through holes on the rear table mounting pads.
6. After locating the table, install the eight (8) table bolts. Seat the taper pins and tighten the
bolts.
7. Attach the front and rear side guides. Install the table end cover. Install the rear table
polycarbonate cover to the table end cover and side guides.
8. Install the paper deflector through the access point inside the front enclosure, under the table.
Depress the deflector with your thumb while installing the assembly to clear the knife bar,
(Figure 5). Attach with two 3/8-16 x 1" socket head cap screws.
One socket screw must be installed from inside the arch. Remove the side guard plate for
access. Both bolts should have shake proof lock washers.
9. Mount the cut button cable assembly to the underside of the table.
10. Mount the main power disconnect switch to the underside of the table.
11. Fasten one end of the encoder cable, chain carrier to the frame of the machine. Route the
carrier chain through the cutout in the table brace. Fasten it to the backgauge carrier. Install
a strain relief cable tie to the backgauge carrier to secure the encoder cable. Plug the
encoder cable into the encoder. (Figure 6, page 16)
Figure 5
6.0 Installation & Setup
15