Job Mode - Challenge CHAMPION 370 XT Operator's Manual

8.12.3.2 Sensor Data
The Sensor Data function provides a list of computer inputs and outputs (proximity switches, etc.)
along with their status (0 for open, 1 for closed). This function allows a service technician to check
the status of a switch without removing any covers. Cuts and backgauge movements are allowed in
this screen so that the technician may observe the status of the inputs and outputs during machine
operation.
8.12.3.3 Clear Memory
The Clear Memory function resets the memory to a known state. All cut positions will be erased
during this operation.
8.12.3.4 Knife Adjust
The knife adjust function provides a way for the service technician to change the knife. In the Knife
Adjust screen, use the up and down arrow keys to toggle to the up or down status as desired, and
press ENTER. Press and hold the cut buttons to send the knife to the desired position.

8.13 Job Mode

-------------------------------
The Champion XG can be programmed for up to 99 different jobs. A job is a sequence of
programmed cut positions. The backgauge moves to each position after a cut cycle is made. Each
job can hold up to 99 send values. Pressing soft-key "F" enters Job mode. When the job mode is
entered, all previously programmed jobs will be displayed along with their name and lock status.
Locked jobs display the word "Lock" after their name. A plus "+" sign at the bottom of the screen
indicates there are more jobs programmed than what are displayed. Pressing the left arrow key and
the down arrow key simultaneously will page down to the next set of
example of how to program a job.
8.13.1 Lock/Unlocking a Job
In the Job Mode screen, the soft-key "E" will display "Lock" or "Unlock" depending on the current
status of the job. If a job is locked, the word "Lock" will be displayed to the right of the job name.
Locking a job prevents it from being edited. To change the lock status of a job, simply move the
cursor to the desired job using the up and down arrow keys, and press the soft-key "E" (Lock/Unlock).
Clamp
Pressure
| | | 14 | | |
C) Up
D) Down
>
1>JOB 1
2>TESTJOB
5>
6>BOBS JOB Lock
7>8.5 X 11 Lock
9>
10>
+
E) Lock G) Erase
F) Copy H) Exit
jobs. Page 38 contains an
8.0 Operation
31