Hydraulic Check - Challenge CHAMPION 370 XT Operator's Manual

14. Connect the tube from the blower to the plastic connector attached to the air channel cover
on the bottom of the table if required. Reconnect the wires to the air blower and solenoid
according to the wiring diagram for the machine model you have.
15. Open each electric eye end-cover. Mount the electric eyes to the machine as shown in
Figure 9. The end-covers are oriented toward the outside of the machine. Connect each
electric eye, leaving the connectors inside the electric eye cases. Replace the end-covers.

6.8 Hydraulic Check

When the machine is shipped, the breather cap should be replaced with a 3/4 NPT plug. This is how
the machine is shipped from the factory. Before the machine can be run for the first time the NPT
plug needs to be replaced with the breather cap. Access the plug behind the small cover on the
hydraulic power unit cover behind the machine.
The hydraulic reservoir is filled with 15 gallons of grade #46 hydraulic oil at the factory. The fluid level
should be checked before operation, and periodically during normal operation. The reservoir is
located behind the cutter, beneath the table (Figure 10). The hydraulic tank has a breather cap that
Figure 8
Figure 9
6.0 Installation & Setup
17