Copying A Job - Challenge CHAMPION 370 XT Operator's Manual

8.0 Operation

8.13.2 Copying a Job

First, select a job to copy by moving the cursor up or down to the desired job number and press the
soft-key "F" (Copy). "Select Copy to #" will be displayed at the bottom of the screen. Enter a job
number for the new job or move the cursor to an existing job and press ENTER. If the new job is
locked, the copy will not be allowed. NOTE: if the new job is not locked, but contains data, the old
data WILL BE LOST.
8.13.3 Erasing a Job
Select a job to erase by moving the cursor to the desired job. Press the soft-key "G" (Erase). "Clear
channel #" will be displayed, followed by YES or NO. Use the up and down arrow keys to toggle to
YES or NO. YES will erase the job, NO will leave the job unchanged. NOTE: locked jobs cannot be
erased.
8.13.4 Creating a New Job
To create a new job, type in a number that is not already assigned to a job and press ENTER
(entering a job number greater than 99 will create job #99). The cursor will move to the line
corresponding to the number you typed in, prompting you for a job name. If no job name is desired,
simply press ENTER again to begin entering send values (see below). To name the job, press the
right arrow key to move the cursor to the first character position. Enter a character of the alphabet by
using the up and down arrow keys to toggle to the desired character. The numeric keys can be used
to enter numbers directly into the job name. When the desired character is in place, use the right
arrow key to move to the next character position. The job name can be up to 10 characters long. A
letter can be removed from the job name by moving the cursor to the undesired character and
pressing the CLEAR key. When finished, press ENTER to save the name and to begin entering send
values. The screen should now look similar to the one below:
-------------------------------
A) Division
8.13.4.1 Entering Send Value
Send values can now be entered by using any of the following methods: 1) Type in the desired value
and press ENTER, 2) Press ENTER at a blank line - this will enter the current position of the
backgauge as a send value, 3) Use the "Cut and Record" feature (described later) or 4) Use the
"Sheet Division" feature.
8.13.4.2 Creating a Stock Loading Position
After typing a send value, pressing the right arrow key, instead of ENTER, will move the cursor to the
right and prompt the operator to enter a rotation indicator mark or Load Zone (LZ). Selecting LZ will
32
Clamp
Pressure
| | | 14 | | |
D) Cut & Rec.
5.070
in JOB1
#1
1>_
E) Insert G) Erase
F) Job H) Exit