Challenge CHAMPION 370 XT Operator's Manual page 17

6.0 Installation & Setup
12. Install the forward and rearward lead screw covers using eight 1/4-20 x ½" button head cap
screws, eight ¼" flat washers, and eight ¼" internal tooth lock washers.
13. Reconnect the backgauge motor cable. From the table, the cable runs through the strain
relief bushing into the motor housing, (Figure 8). Attach the wires according to the wiring
schematic in the back of this manual for the machine model you have.
16
Figure 6
Figure 7
Cable
Ties