Challenge CHAMPION 370 XT Operator's Manual page 35

8.0 Operation
decrease the clamp pressure, or use the numeric keypad to enter a number from 0 to 15 (see
Adjusting the Clamp Pressure section, page 24 for information about the clamp pressure setting).
This will complete the entry for the current line and move the cursor to the send value of the next line.
NOTE: All new entry lines will have the same clamp pressure as the one above it, until it is changed.
8.13.4.5 Cut and Record
To use this feature when creating a new job, simply send the backgauge to a desired position using
the backgauge glide control or by using SEND, then make a cut. The current backgauge position will
automatically be displayed in the next available cut location and the operator will be prompted to
press ENTER to record the current value. If ENTER is not pressed, the value will not be recorded
into the job as a send value. This can be very convenient for setting up a program when the actual
cut positions are not known.
8.13.4.6 Sheet Division Feature
The Champion XG has a sheet division feature that automatically creates a complete set of send
values using the parent and finished sheet sizes specified by the user. Since this feature creates an
entire set of send values, it is best to use it only when creating a new job. However, this feature can
also be used when editing or using an existing job. It will simply insert the new set of send values
after the current send value.
Begin by pressing soft-key "A" (Division). The display will be similar to the following:
-------------------------------
The program guides the operator through the steps of entering the necessary dimensions. Then the
program asks if the columns are to be cut separate (as opposed to stacking the columns and cutting
them all at once). Press "1" for Yes or "0" for No. The display will now look similar to the one shown
next (it may vary based on the input):
34
C) Up
D) Down
5.070
in #1
DIM A>_
DIM B
DIM C
DIM D
Enter Dimension A.
E) Maint
F) Job H) Repeat