Label Cutting - Challenge CHAMPION 370 XT Operator's Manual

8.13.8 Label Cutting

A label-cutting feature is also provided on the Champion XG. After providing the label quantity, size,
and gutter, the machine will automatically create a programmed job. Begin by entering the job mode,
select a job number and name (optional) then depress ENTER. Depress the soft-key "C" (Label)
under the left hand display. The display will be similar to the following:
The program guides the operator through the steps of entering the necessary information. A & B are
label quantities, C & D are the actual label size and E & F are gutter dimensions. Then the program
asks if the columns are to be cut separate (as opposed to stacking the columns and cutting them all
at once). Press "1" for Yes and "0" for No. The display will now look similar to the one shown on the
next page (it will vary based on the input).
Use the up and down arrow keys to scroll through the possible options (if more than one). The left
display will show each choice visually. Select the desired option, then press ENTER. At this point
A
5.070
in
*Label Cutting*
QTY A>_
QTY B
DIM C
DIM D
DIM E
DIM F
Enter Quantity A.
E) Maint
F) Job H) Repeat
5.070
QTY QTY
OPT OUT CUTS
1 8
RE-ENTER (0)
Select and Press Enter
H) Exit
8.0 Operation
#1
9
37