Table of Contents
Advertisement
6.0 Operation
6.11 Electronically Positioning the Backgauge
6.11.1 Control Panel - Definition of Keys
IN/MM Key
This key toggles the display to show the position and programmed send values in inches (e.g. 5.250),
or millimeters (e.g. 133.3).
Send Key
The SEND key is used to send the backgage to any valid position. If an attempt is made to send the
backgage to an illegal position, an error message will be displayed at the bottom of the screen stating
"EXCEED LIMIT". In the Job mode, the SEND key will also advance the backgage to the next
sequential cut position before performing the cut.
Push-Out Key/Hold-To-Run Backgage Key
This key has 2 functions. It is used to move the backgauge forward 5 inches (or to the most forward
position) and then return it to its previous position. This allows paper to be removed from the cutter
without putting hands under the knife and clamp. It also allows backgauge to move forward under
program control for dimensions less than 2 inches (50.8mm).
the backgage control knob to move the paper to an area where it can be reached.
Clear Key
The CLEAR key is used to clear error messages and the current entry line.
Enter Key
The ENTER key selects items in the maintenance mode and processes data that has been entered in
the other modes.
Soft-Keys
The soft-keys are labeled as A, and B. The definition for these keys change depending on the
operating mode. The function of the key can be found on the bottom of the display screen.
Arrow Keys
The four arrow keys can be used in almost all screens. The arrow keys are primarily used for moving
the cursor around on the screen, or to toggle between highlighted selections. In some screens, the
left arrow key acts as a backspace key.
Contrast Control
The contrast of the display can be adjusted by pressing the up arrow or down arrow key in the send
mode.
Math Keys
The +, -, X, / keys are used for math functions.
16
Never place hands in the clamp and knife area. Use the push-out key or
Advertisement
Table of Contents
