Clamp Pressure Adjustment - Challenge CHAMPION 370 XT Operator's Manual

8.0 Operation
Additional jogging aids can be purchased at your authorized Challenge dealer. (P/N A-12608-6)

8.5 Clamp Pressure Adjustment

The clamp pressure can be adjusted by pressing soft-key "C" (Up) to increase the pressure, and soft-
key "D" (Down) to decrease the pressure. The pressure scale ranges from 0 to 15, 15 being the
maximum.
8.6 Pre-Clamping
All Champion cutters are equipped with a low pressure clamping feature which allows the operator to
clamp paper before beginning the cut cycle. To use this feature, press the footswitch until the clamp
presses the paper. While holding the foot switch down, press the cut buttons. Release it once the
cut has been completed. Although this is low pressure clamping, avoid placing hands under the
clamp at all times.
8.7 Knife Change Alarm and Lubrication Alarm
The Champion 370 XG has two built in alarms that will be displayed after a certain number of cuts.
The knife alarm displays a message to remind the operator to change the knife. The lube alarm
displays a message to remind the operator to have the machine lubricated. The lube alarm will also
display the name and phone number of the Challenge dealer from which the machine was purchased.
To reset either alarm, or to change the knife alarm value, see the Knife Count section on page 30.
The lube alarm value is factory set at 2,500 cuts and cannot be changed.
24
Figure 14
Always remove the jogging aid from the table before making a cut.