Maintenance Mode - Challenge CHAMPION 370 XT Operator's Manual

8.12 Maintenance Mode

-------------------------------
The maintenance mode is an area where many machine functions can be set or modified. The four
principle functions are: Language, Parameters, Diagnostic, and Knife Adjust. To select a particular
function, use the up and down arrow keys to toggle to the desired function and press ENTER. See
the following descriptions for an explanation of each function.
8.12.1 Language
In the language screen, use the up and down arrow keys to toggle to the desired language, and press
ENTER. All messages will be displayed in the selected language.
8.12.2 Parameters
In the parameter screen, use the up and down arrow keys to toggle to the desired parameter, and
press ENTER. See the descriptions that follow for an explanation of each parameter.
8.12.2.1 Time-out
This parameter sets the amount of idle time for which the screen saver activates and the line lights
and hydraulic motor turn off. The choices are 2, 5, 10, 20, and 30 minutes. In the time-out screen,
use the up and down arrow keys to toggle to the desired time-out, and press ENTER.
8.12.2.2 Push-out
Normally, whenever the backgauge is sent to a larger dimension, a five-inch (127mm) push-out is
performed to aid the operator in accessing the paper. In some situations, it may be necessary to turn
this feature off. It is recommended that this feature be left on whenever possible. In the push-out
screen, use the up and down arrow keys to toggle to the on or off status as desired, and press
ENTER.
8.12.2.3 Accuracy Adjust
This parameter provides a means for adjusting the accuracy of the backgauge. To change the
accuracy, send the backgauge to 2 inches (50.8mm) and cut some paper. Measure the paper, and
type in what you actually measure. The computer will calculate the amount of error and will
compensate. A value may also be added to or subtracted from the current value.
Clamp
Pressure
| | | 14 | | |
C) Up
D) Down
5.070
in
MAINT MENU
LANGUAGE
PARAMETERS
DIAGNOSTICS
KNIFE ADJUST
Select and press enter
G) Send
F) Job H) Exit
8.0 Operation
29