Editing An Existing Job - Challenge CHAMPION 370 XT Operator's Manual

-------------------------------
Use the up and down arrow keys to scroll through the possible layouts. The left display will show
each choice visually. Select the desired layout by pressing ENTER. At this point the send values will
be automatically calculated and entered, and the job will be complete and ready for use. To make
changes, edit the job as described in the "Editing a Job" section below.
8.13.4.7 When Finished
When finished entering send values you may exit the current job by pressing soft-key "B" (Job) to go
back to the job mode screen or soft-key "D" (Exit) to exit to send mode. Or you may use the current
job for cutting by pressing the down arrow at the last line and following the instructions in the
"Running a Job" section (page 36).

8.13.5 Editing an Existing Job

8.13.5.1 Editing the Job Name
The job name can be edited (or added if an existing job does not have a name) in the job mode
screen. To edit the name, move the cursor down to the desired job number by pressing the down
arrow key. Then press the right arrow key to move the cursor to the desired character position and
edit the character by pressing the up or down arrow keys to toggle between characters of the
alphabet. Numbers can be entered directly by using the number keys. Pressing CLEAR clears the
current character. When finished, you may either go to the current job by pressing ENTER, or go to a
different job, or exit job mode.
8.13.5.2 Editing Send Values
To edit send values of an existing job, start by opening the desired job from the job mode screen. A
job is opened by one of two methods: pointing at the desired job with the cursor and pressing
ENTER, or by entering the job number with the keypad and pressing ENTER. Once a job has been
opened, the current job number will be displayed in the upper right corner. NOTE: If the job is
locked, it cannot be edited.
Send values can now be edited by moving the cursor up or down to the desired send value and then
typing over the existing value. To page up and page down, press the left and down arrow keys
simultaneously.
C) Up
D) Down
5.070
QTY QTY
OPT OUT CUTS
1 8
2 8
3 8
4 6
5 8
6 6
RE-ENTER
H) Exit
8.0 Operation
9
9
9
7
9
7
35