Challenge CHAMPION 370 XT Operator's Manual page 34

make it impossible to cut at that position. Pressing both cut buttons on a position marked at a
Loading Zone will prompt the backgauge to move to the next position in the job. Using a loading
position eliminates the need to reach into the knife/clamp area of the cutter when loading a job.
8.13.4.3 Entering Rotation Mark
After entering a send value, pressing the right arrow key, instead of ENTER, will move the cursor to
the right and prompt the operator to enter a rotation indicator mark. The display will look similar to the
one shown below:
Turn Indicator
Off
ccw
cw
180 Turn
Load Zone LZ
Select & Press Enter
Use soft-keys "C" and "D" to choose a turn indicator. Pressing ENTER will place an indicator mark to
the right of the send value, as shown below:
-------------------------------
When the desired indicator mark is in place, press the right arrow key. The cursor will move to the
right and prompt the operator to enter a clamp pressure (see the following section).
NOTE: All new entry lines will have the same turn indicator mark as the one above it, until it is
changed.
8.13.4.4 Entering the Clamp Pressure
A separate clamp pressure can be entered for each cut in a job. To enter the desired clamp
pressure, first enter the desired send value (described above), then press the right arrow key and
enter the rotation mark if necessary (described above), then press the right arrow key again to move
the cursor to where the clamp pressure can be entered. Use soft-keys "C" and "D" to increase or
>
<
>>
C) Up
D) Down
Clamp
Pressure
| | | 14 | | |
C) Up
D) Down
5.070
in JOB1
#1
1> 5.070 _
H) Exit
5.070
in JOB1
#1
1> 5.070 >>
H) Exit
8.0 Operation
33