An Example Job – Xg Model - Challenge CHAMPION 370 XT Operator's Manual

8.0 Operation
the send values will be automatically calculated and entered. The job will be complete and ready for
use. To make changes, edit the job as described in the "Editing a Job" section below.
8.14 An Example Job – XG Model
The following is an example of how to program a job that will be used to make two cuts: one at 8.5"
and one at 11".
1. Turn on the machine and press CLEAR to preset the backgauge. Press the soft-key "F"
(Job) to go to job mode.
2. Type in an unused job number and press ENTER. Note: It must be a number that does not
correspond to an existing job. All existing jobs will be displayed on the screen (you may have
to scroll through them to see them all). If you wish to replace an existing job with the new job,
first erase the existing job by moving the cursor to it and press the soft-key "G" (Erase). Now
type in the new number and press ENTER. In this example, job #'s 1, 2, 5, and 6 already
exist. We will use job # 7 for our new job. Press "7" and ENTER.
3. The cursor will move down to the new job number. At this point, press the right arrow key
once to move the cursor to the first character position. Now name the job "8.5 X 11". To do
this, press "8" on the number keypad. Then press the decimal "." key and so on. To enter
the spaces and the letter "X", use the up and down arrow keys to toggle through the alphabet
and press the right arrow key to move to the next character position.
Now press ENTER to begin programming the job.
4. To enter the first send value of 8.5", simply type in 8.5 and press ENTER. The cursor will
move to the second line. Now type 11 and press enter. At this point, you could exit and save
the job by pressing the soft-key "H" (Exit) to exit to send mode, or the soft-key "F" (Job) to exit
back to the job mode screen. However, lets use this job to cut paper.
5. Press the down arrow key once. This will remove the blank line 3 and move the cursor to the
first send value (8.5"). Now press SEND. The backgauge will move to the 8.5" position.
Place the paper to be cut against the backgauge and press the cut buttons. Once the cut
cycle is complete, the backgauge will push out the paper and move to the next send value
(11"). Now position the paper again and make another cut. After the cut is made, the
backgauge will push out the stock and return to the first cut position, ready to repeat the
current job.
6. Now lets lock the current job so it cannot be edited. First, exit back to job mode by pressing
soft-key "F" (Job). Now move the cursor down to the new job using the down arrow key.
Now press the soft-key "E" (Lock) to lock the job. A lock symbol will appear indicating the job
has been locked.
7. To exit back to send mode, press the soft-key "H" (Exit).
38