Breaker Control - GE D60 Instruction Manual

FRONT PANEL INTERFACE
3. Remove the tool and attached user-programmable pushbutton label.
4. Slide the new user-programmable pushbutton label inside the pocket until the text is properly aligned with the
4 buttons.

4.2.9 Breaker control

The D60 can interface with associated circuit breakers. In many cases the application monitors the state of the breaker,
that can be presented on faceplate LEDs, along with a breaker trouble indication. Breaker operations can be manually
initiated from the faceplate keypad or automatically initiated from a FlexLogic operand. A setting is provided to assign
names to each breaker; this user-assigned name is for the display of related flash messages. These features are provided
for two breakers; the user can use only those portions of the design relevant to a single breaker, which must be breaker 1.
It is assumed in the following discussion that the
setting is "Enabled" for each breaker.
FUNCTION
4-28
SETTINGS  SYSTEM SETUP  BREAKERS  BREAKER 1(2)  BREAKER
D60 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES