CHAPTER 5: SETTINGS
CONTROL ELEMENTS
For correct operation of the open pole detector, the breaker control, trip output, and single-pole autoreclose features must
be enabled and configured properly. When used in configuration with only one breaker, set the
to
BREAKER 2 FUNCTION
"Enabled" and the
setting to "On" (see the Breaker Control section earlier in this chapter for details).
BREAKER 2 OUT OF SV
Figure 5-198: Open pole detector logic (Sheet 1 of 2)
5
D60 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
5-343