Setting Groups - GE D60 Instruction Manual

CONTROL ELEMENTS
TRIP BUS 1 RESET DELAY
to allow the breaker or contactor to perform a required action.
TRIP BUS 1 INPUT 1
bus.
TRIP BUS 1 LATCHING
required or user acknowledgement of the relay response is required.
— The trip bus output is reset when the operand assigned to this setting is asserted. Note that the
TRIP BUS 1 RESET
operand is pre-wired to the reset gate of the latch, As such, a reset command from the front panel interface or via
communications resets the trip bus output.
5

5.8.3 Setting groups

SETTINGS  CONTROL ELEMENTS  SETTING GROUPS
 SETTING GROUPS

5-284
— This setting specifies a time delay to reset an output command. Set the time delay long enough
to — These settings select a FlexLogic operand to be assigned as an input to the trip
TRIP BUS 1 INPUT 16
— This setting enables or disables latching of the trip bus output. This is typically used when lockout is
Figure 5-166: Trip bus logic
SETTING GROUPS

FUNCTION: Enabled
SETTING GROUPS BLK:

Off
GROUP 2 ACTIVATE ON:

Off
GROUP 6 ACTIVATE ON:

Off
GROUP 1 NAME:

GROUP 6 NAME:

Range: Disabled, Enabled
Range: FlexLogic operand
Range: FlexLogic operand

Range: FlexLogic operand
Range: up to 16 alphanumeric characters

Range: up to 16 alphanumeric characters
D60 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
RESET OP