Table of Contents
Advertisement
Braking system
- Repeat the measurement in at least 6 points of
the disc.
- Check that the measurements do not give devi-
ations higher than .....
- Check that the brake disc unit rotates regularly
using the specific tool fixed on the brake caliper
support as shown in the figure.
- Suitably fix the flange to the wheel axle with the original nut and spacer and a Ø 17-mm bearing
N.B.
SO AS NOT TO GET A DISTORTED READING, CAUSE THE DRIVEN PULLEY SHAFT TO TURN
IN ORDER TO ROTATE THE DISC.
Specific tooling
020335Y Magnetic support for dial gauge
Characteristic
Max. deviation allowed:
0.1 mm
- If you detect incorrect values, replace the disc. If the anomaly persists, replace the hub.
Front brake disc
Removal
- Remove the front wheel.
- Adequately support the front wheel and remove
the break disc operating on the five screws shown
in the photograph.
BRAK SYS - 310
Nexus 500
Advertisement
Table of Contents
