Refitting The Intake Manifold; Tappet Cover Fixing Screws - Gilera Nexus 500 Workshop Manual

Engine
- Tighten the two screws indicated in the figure with
«1» and «2» to limit the reciprocal sliding of the
cover surface with the head surface.
- Tighten the remaining 4 screws in a crossed se-
quence (3, 4, 5, 6).
N.B.
CHECK THE PROPER POSITION OF THE GASKET.
Locking torques (N*m)

Tappet cover fixing screws

- Install the transmission cover and the relevant net
filter and the outside transmission cover as descri-
bed in the "Automatic transmission" chapter.
- Install the cooling system sleeves using new
bands, as described in the "Flywheel cover" chap-
ter.

Refitting the intake manifold

- Install the intake manifold on the engine.
- Insert the 3 fastening screws, one of which with
a support band for the cooling system sleeve, and
tighten to the prescribed torque.
Locking torques (N*m)
Inlet manifold screws
ENG - 158
7 - 9
11 ÷ 13
Nexus 500