Flywheel Cover - Gilera Nexus 500 Workshop Manual

Engine
- Position the 7 set screws, tighten them to the prescribed torque, being careful of the position of the
bands holding the vent tube, and the position of the 3 shortest screws as indicated in the figure.
- Refill with the prescribed oil to the Max. level.
Recommended products
AGIP ROTRA 80W-90 rear oil hub
SAE 80W/90 Oil that exceeds the requirements of API GL3 specifications
Characteristic
Quantity:
approx. 250 cc
Locking torques (N*m)
Rear hub cover screws 24 ÷ 27

Flywheel cover

- Remove the three bands shown in the figure for
an easier removal of the flywheel cover, remove
the feed hoses and disconnect the return hose
from the pump cover.
N.B.
THE BANDS MUST BE REPLACED. TO RE-
MOVE THEM, OPEN WITH A SCREWDRIVER
OR CUT THEM.
BE CAREFUL NOT TO DAMAGE THE PLASTIC
UNIONS.
Removing the hub cover
- Drain the engine oil by removing the drainage
cap.
- Prepare a suitable container to collect the oil.
ENG - 102
Nexus 500