Side Fairings; License Plate Holder - Gilera Nexus 500 Workshop Manual

Chassis

Side fairings

- Remove the side rear union.
- Remove the passenger handles.
- Remove the bottom cover.
- Remove the footboard supports
- Remove the central union.
- Remove the screws shown in the figure (in the
left side, a screw is located below the air inlet union
of the filter).
- Remove the rear fixings and the complete side.

License plate holder

- Remove the lower cover.
- Remove the four retaining screws (2 per side)
and disconnect the electrical connectors.
- In order to access the licence plate bulb it is suf-
ficient to remove the two retaining screws of the
rear cover from the support and to pull out the
complete bulb holder.
CHAS - 340
Nexus 500