Table of Contents
Advertisement
Nexus 500
Refitting
- Perform the removal operations in the reverse
order according to the direction of rotation of the
disc, as shown by the arrow on the disc
- Tighten the 5 screws at the prescribed torque.
Locking torques (N*m)
Front brake disc mounting
Disc Inspection
- Using a micrometer, check the disc thickness as
shown in the figure.
Characteristic
Standard thickness:
4 +02-01mm
- Repeat the measurement in at least 6 points of
the disc.
- Check that the measurements do not give devi-
ations higher than .....
- Remove the front brake caliper
- Position the magnetic support base of the com-
parator on the plate.
- Place the comparator close to the maximum diameter of the disk.
- Lift the front wheel, make it rotate and check the disc deviation
Specific tooling
020335Y Magnetic support for dial gauge
Characteristic
Max deviation:
xxx mm
5 ÷ 6 •
Braking system
BRAK SYS - 311
Advertisement
Table of Contents
