Table of Contents
Advertisement
Nexus 500
15 - Arrange a multimeter with positive prod on pin
13 and negative prod on pin 23. Set the switch to
"ON" with switch to "RUN" and side stand raised.
Check the presence of battery voltage during the
fuel pump timing.
13 - 23 = battery voltage for 2 seconds.
YES go to 16 NO go to 17
16 - The injector electric circuit is steady Repeat
the checks. If the fault continues, check the control
unit connector. If necessary, replace the electronic
control unit.
17 - Repeat the test using the resistance multime-
ter. Check the resistance between pin 13 and pin
87 (black/green cable) of the pump remote control
switch.
13 - black/green = 14.5Ω ± 5% (resistance of the
injector)
YES go to 19 NO go to 18
18 - No continuity. Disconnect the connector and
repeat the resistive check directly at the injector
terminals.
Resistance = 14.5 Ω ± 2%
YES go to 21 NO go to 22
19 - Check the earth insulation of the injector negative line. Disconnected control unit and injector
connectors.
13 - 23 = Ω infinity
NO go to 20
20 - Repair or replace the cable harness.
21 - Check the continuity between the injector power supply connector (red - yellow) and pin 13. Restore
the continuity, if required, or replace the wiring
22 - Replace the injector.
Injection
INJEC - 235
Advertisement
Table of Contents
