Ht Coil - Gilera Nexus 500 Workshop Manual

Injection
infinite (>1MΩ)
YES go to 19 NO go to 18
18 - Check the sensor and control unit connectors.
Repair or replace the injection wiring
19 - Measure the alternated voltage between pins
7 and 12 with engine at start-up speed.
Electric characteristic
7-12 =
approx. 0.8 - 4.5 V eff
Revolution speed =
approx. 300-400 rpm
YES go to 20 NO go to 21
20 The sensor circuit is in conformance.
Use the parameter function to check if the engine rpm indication is present when trying to start.
If not, carefully check the ECU connection connector and replace it if necessary.
21 Check the air gap and magnetic activity of the sensor.
See the "Combustion unit and distribution" chapter.
If there is no magnetic activity replace the sensor.
N.B.
-THE SENSOR CABLE MUST BE PROPERLY INSTALLED FOR SERVICING.
-DO NOT FORCE THE CABLE.
-A POOR CABLE SHIELDING CAN IMPAIR THE ENGINE PERFORMANCE AT HIGH SPEED.

HT coil

This section describes the ignition system operation.
Circuit diagram
Electric characteristic
TERMINALS: 20 - 23
CONDITIONS : During the pump timing with engine off.
STANDARD: Battery voltage
INJEC - 252
Nexus 500