Table of Contents
Advertisement
Troubleshooting > Responding to Messages
Error Message
SSD error.
Staple jam.
System error.
T
Error Message
The cover is open.
The device cannot
be connected
because allowed
connections would
be exceeded.
The manufacturer
assumes no
responsibility for
damage caused by a
non-genuine toner.
The phone receiver
is off the hook.
The SD Card is not
formatted.
Checkpoints
-
-
-
Checkpoints
Is there any cover which is
open?
Is the top cover of the document
processor open?
Are three handheld devices connected
simultaneously?
Is the installed toner container our own
brand?
-
Is the SD Card formatted by this
machine?
Corrective Actions
An error has occurred on SSD. Job
is canceled. Select [End].
The error cords are as follows.
01: The amount of data that can be
saved at once has been exceeded.
Turn the power OFF/ON. If the
error still occurs, divide the file into
smaller files. If the error occurs
after the file is divided, the
specified file may be damaged.
Delete the file.
04: Insufficient space on SSD to
complete this operation. Move data
or delete unneeded data.
NOTE
Please be aware that when you
carry out initialization of the
system, the data saved in SSD
will be erased.
If a staple jam occurs, the machine
will stop and the location of the jam
will be indicated on the screen.
Leave the machine on and follow
the instruction to remove the
jammed staple.
System error has occurred. Follow
the instructions on the screen.
Corrective Actions
Close the cover indicated on the
screen.
Close the document processor
cover.
Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
We will not be liable for any
damage caused by the use of third
party supplies in this machine. If
you want to continue, select [Next
>].
Put down the receiver.
Select [Format] from [Common
Settings], under [System Menu].
11-20
Reference
Page
-
-
-
Reference
Page
-
-
-
10-4
-
-
Advertisement
Table of Contents
