Using Intercom As The Line For Autodial - Nortel Enterprise Edge 2.0 Manual

38 Time savers for making calls

Using intercom as the line for Autodial

Æ
If you press
a valid line pool access code or a destination code. If access codes for line pool or
destination codes change, remember to re-program autodial numbers.
Displays
987___
QUIT BKSP
Autodial full
Button erased
Enter digits
QUIT
Intercom #: ___
QUIT
Invalid number
Press a button
QUIT
Program and HOLD
Program and OK
QUIT
Programmed
For other displays, see
Enterprise Edge 2.0 Feature Programming Telephone Guide
as the line for an external autodial number, you must include
Continue to enter digits until the number is complete. Press
à BKSP
OK or
ú OK
Press or
The memory allocated to autodial numbers in your Enterprise
Edge system is full.
While programming external Autodial, you erased the button by
ú
pressing or
Enter the number you want to program (selecting the line first if
OK
necessary) exactly like you were making a call.
Enter the internal telephone number you want to program.
You are programming an internal autodial button and have
entered a number that is not an internal number on your system.
Enter a valid internal number. If the number you are entering is
a destination code, use external autodial.
Press the memory button you want to program.
Enter the number you want to program on the button, then press
ú
.
Enter the number you want to program on the button, then press
ú OK
OK
or . You can include a line or line pool selection
in an autodial sequence by selecting the line before entering
any digits.
The number is correctly stored on the button.
Common feature displays
to erase an incorrect digit.
when you finish.
OK
before entering any digits.
on page 121.
P0911589 Issue 03