Using Intercom As The Line For Autodial - Nortel Modular ICS 4.0 Manual

64 / Time savers for making calls
If you select a line before pressing the autodial button, the call
goes out on the line you have selected instead of the line that
is part of the autodialer programming.
For the M7100 telephone, an external autodialer can be
programmed only by using a line and not a line pool.
Tip -
number, the call uses your prime line (if you have one).

Using intercom as the line for Autodial

If you press
number, you must include a valid line pool access code or a
destination code. If line pool access codes or destination codes
are changed, remember to reprogram autodial numbers.
Displays
987___
QUIT
Autodial full
Button erased
Enter digits
QUIT
Intercom #: ___
QUIT
Modular ICS 4.0 System Coordinator Guide
If you do not include a line selection in an autodial
∆
as the line for an external autodial
Continue to enter digits until the number is
BKSP OK complete. Press
erase an incorrect digit. Press
OK when you are finished.
The memory allotted to autodial numbers in
your Norstar system is full.
While programming external Autodial, you
erased the button by pressing
OK
Enter the number you want to program
OK
(choosing the line first if necessary) exactly
as if you were making a call.
Enter the internal telephone number you
want to program.
√
before entering any digits.
˙
or BKSP to
or
˙
or
P0881591 Issue 01