Nortel Enterprise Edge 2.0 Manual page 85

Figure 8 Connecting the cords (International)
1
Press tight until it clicks, to
attach the support
Press here to remove the
support.
1. Before trying to carry out any work on the telephone, ensure that the line cord
is disconnected from the wall socket.
2. To remove any of the cords, press the release latch on the plug and carefully
pull the plug from the socket.
3. Connect the handset cord to the jack labelled with the telephone icon and
route the cord as shown.
4. If you are using a headset, route the cord along the channel in the base and
connect the cord to the telephone jack that marked with the headset icon.
5. Route the line cord through the support and connect the cord to the telephone
jack that marked with the jack icon.
6. Attach the support using either pair of slots; to raise the back of the telephone
to its highest position, use these slots.
7. When the above work is complete, plug the line cord back into its wall socket.
P0911589 Issue 03
2
.
Enterprise Edge 2.0 Feature Programming Telephone Guide
Telephone features 85