Using Intercom As The Line For Autodial - Nortel M7410 Installation And Maintenance Manual

38 Time savers for making calls

Using intercom as the line for Autodial

If you press
∆
a valid line pool access code or a destination code. If line pool access codes or
destination codes are changed, remember to reprogram autodial numbers.
Displays
987___
QUIT BKSP
Autodial full
Button erased
Enter digits
QUIT
Intercom #: ___
QUIT
Invalid number
Press a button
QUIT
Program and HOLD
Program and OK
QUIT
Programmed
For other displays, see
Enterprise Edge Feature Programming Telephone Guide
as the line for an external autodial number, you must include
Continue to enter digits until the number is complete. Press
or BKSP
√
OK
or OK when you are finished.
˙
The memory allotted to autodial numbers in your Enterprise
Edge system is full.
While programming external Autodial, you erased the button by
pressing or
˙
Enter the number you want to program (choosing the line first if
necessary) exactly as if you were making a call.
OK
Enter the internal telephone number you want to program.
You are programming an internal autodial button and have
entered a number that is not an internal number on your system.
Enter a valid internal number. If the number you are entering is
a destination code, use external autodial.
Press the memory button you want to program.
Enter the number you want to program onto the button, then
press .
˙
Enter the number you want to program onto the button, then
press or OK
˙
OK
selection in an autodial sequence by selecting the line before
entering any digits.
The number is stored on the button.
Common feature displays
to erase an incorrect digit. Press
OK before entering any digits.
. You may include a line or line pool
on page 125.
P0908510 Issue 02