Cisco ONS 15454 Troubleshooting Manual page 59

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
WID-6336 Changing the card to EFEC mode will cause the ports 1 and 2
to be disabled.
Do you want to continue?
WID-6337 CE-MR-10/CE-MR-6 card does not validate the Ethernet FCS
when traffic is received from optical side. This can result in
errored frames from optical side being forwarded to the peer
device via front ports. It would be left to the peer device to
detect the errors and discard the frames.
It is suggested to enable the FCS option on both ends of the
circuit. The GFP FCS will be used to discard errored frames.
The discarded frames will be accounted under the performance
pane for the POS port.
WID-6338 Ingress COS setting is not compatible with QinQ mode.
WID-6339 Some circuits may become partial as part of this upgrade and
would need to be reconfigured.
WID-6340 One or more QinQ rules have not been deleted because they are
not related to the current circuit.
WID-6341 The Functional view on {0} is disabled.
WID-6342 Changing the {0} settings might be traffic affecting.
Do you want to continue?
WID-6343 The selected file name is too long.
File names (including the full path) must be less than 254
characters.Please enter a valid file name.
EID-6344 It is detected a shelf mismatch condition.
EID-6345 The line termination is invalid.
EID-6346 The overhead is not supported.
EID-6347 A patchcord was expected for a successful operation.
EID-6348 A Virtual link already exists on the same path.
EID-6349 The overhead creation has failed.
EID-6350 The unprotected line is not present
EID-6351 The port status is active.
EID-6352 IPv4 access cannot be disabled when IPv6 mode is not enabled
on the node.
EID-6353 IPv4 access cannot be disabled when the node is in Multishelf
configuration.
EID-6354 Disabling IPv4 access may lead to loss of communication with
the node.
Make the change anyway?
EID-6355 IPv6 access cannot b disabled when IPv4 Access is disabled on
the node.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
4-59