Cisco ONS 15454 Troubleshooting Manual page 39

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
WID-5065 If you apply routing constraints to more than {0} nodes,
performance might be affected and the operation might require
more time than expected.
Select Yes if you intend to proceed in spite of this risk, or No if
you prefer to review your selection.
WID-5066 The routing constraints will be lost.
Are you sure you want to reset your changes?
WID-5067 The routing constraints will be lost.
Are you sure you want to leave this panel?
EID-5068 The routing constraints could not be applied.
EID-5069 A source node cannot be added to either of these lists.
EID-5070 A destination node cannot be added to either of these lists.
EID-5071 This node already belongs to one of these lists.
EID-5072 An OCH-Trail tunnel link was found but without any associated
circuit.
EID-5073 You are creating an unprotected link from a protected port.
Do you want to continue?
EID-5074 Deleting OCH DCN circuits will cause a loss of connectivity to
nodes in the circuit path that do not have other DCN
connections.
Do you want to continue?
EID-5075 The VLAN ID must be a number between 1 and 4093.
EID-5076 An error occurred while provisioning the VLAN ID.
The VLAN ID is already present in the current profile
EID-5077 An error occurred while provisioning the VLAN database
profile.
{0}
EID-5078 The VLAN merge is not complete.
You forgot to fill {0} record(s).
EID-5079 An error occurred while validating the provisionable patchcord. Refer to the error message text.
EID-5080 No rolls are available.
EID-5081 An error occurred while tracing the RPR ring:
{0}
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Select a node other than the source node to
add to the route.
Select a node other than the destination
node to add to the route.
The node is already selected either in
include or exclude list in the OCH circuit.
Create an OCH-Trail circuit associated with
the link.
Refer to the error message.
Refer to the error message.
Enter a number between 1 and 4093.
Select a VLAN ID that is not present in the
current profile.
CTC could not save the VLAN profile to the
file name mentioned.
Fill in the number of records specified and
then proceed.
You cannot delete a roll without selecting a
roll.
The circuit reference is invalid.
4-39