Cisco ONS 15454 Troubleshooting Manual page 51

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6117 CTC attempted to access an OCH-Trail edit that has been
destroyed.
WID-6118 The following slots are provisioned but do not have cards
installed:
{0}
CTC will assume they are ITU-T interfaces.
EID-6119 The shelves could not be rearranged.
{0}
EID-6120 This equipment does not support multishelf.
WID-6121 This internal patchcord cannot be provisioned because the
endpoints have no compatible wavelengths.
EID-6122 The wizard could not be started.
{0}
EID-6123 The OSI request can not be completed successfully.
EID-6124 The ALS recovery pulse interval is invalid.
EID-6125 The ALS recovery pulse duration is invalid.
EID-6126 The current setting does not support the specified ALS mode.
EID-6127 All enabled routers are required to have the same area.
EID-6128 A software download is in progress. Configuration changes that
result in a card reboot cannot take place during a software
download.
Please try again after the software download is done.
EID-6129 The payload configuration and card mode are incompatible.
EID-6135 A DCC is present.
EID-6136 An error occurred during provisioning: {0}
EID-6137 Multishelf cannot be disabled.
{0}
EID-6138 The LAN configuration is invalid.
EID-6139 Invalid card(s) are present.
Please remove all non-MSTP cards and try again.
EID-6140 The shelf identifier for a subtended shelf cannot be provisioned
through CTC. It must be changed using the LCD.
EID-6143 The DHCP server could not be changed.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
The resource cannot be accessed because it
is released or fully utilized.
Refer to the warning message text.
One of the following conditions is present:
duplicate shelf positions, invalid shelf
positions, or concurrent movement (two
CTC sessions are attempting to rearrange
the shelves at the same time.)
Refer to the error message text.
The end points of an internal patchcord
should have compatible wavelengths.
CTC was unable to initiate the wizard due
to the specified reason.
A communication failure occurred.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
A data communication channel (DCC)
already exists.
CTC was not able to provision the specified
port or card.
Multishelf is not supported on equipment, is
already disabled, or modules on the shelf
are currently in use.
Verify the LAN configuration.
Non-DWDM cards cannot be added to an a
DWDM node. Remove the cards.
Refer to the error message text.
Refer to the error message text.
4-51