Cisco ONS 15454 Troubleshooting Manual page 21

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-3115 The LAN metric must be between 1 and 65535.
EID-3116 The LAN metric is invalid.
EID-3117 If OSPF is active on the LAN, no DCC area IDs may be 0.0.0.0.
Please change all DCC area IDs to non-0.0.0.0 values before
enabling OSPF on the LAN.
EID-3118 If OSPF is active on the LAN, the LAN area ID cannot be the
same as the DCC area ID.
EID-3119 An error occurred during validation.
EID-3120 No object of type {0} was selected for deletion.
EID-3121 An error occurred while deleting {0}.
EID-3122 No object of type {0} was selected to edit.
EID-3123 An error occurred while editing {0}.
EID-3124 The {0} termination is in use.
Delete the associated OSPF range table entry and try again.
EID-3125 No {0} terminations were selected.
EID-3126 The {0} termination could not be edited.
EID-3127 Orderwire cannot be provisioned because the E2 byte is in use
by {0}.
EID-3128 The authentication key cannot exceed {0} characters.
EID-3129 The authentication keys do not match!
EID-3130 An error occurred while creating the OSPF area virtual link.
EID-3131 An error occurred while creating the OSPF virtual link.
EID-3132 An error occurred while setting the OSPF area range: {0}, {1},
false.
EID-3133 The maximum number of OSPF area ranges has been exceeded. OSPF area ranges exceeded the maximum
EID-3134 The area ID is invalid. Use the DCC OSPF area ID, LAN port
area ID, or 0.0.0.0.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
The LAN metric should be in the range of 1
to 65535.
The LAN metric is invalid.
Refer to the error message text.
LAN must be part of a different OSPF area
other than the DCC network.
CTC was unable to validate the values
entered by the user. This error message is
common to several different provisioning
tabs within CTC (examples include the
SNMP provisioning tab, the General>
Network provisioning tab, the Security >
Configuration provisioning tab, etc.).
Choose an object of the specified type to
delete.
There is an error deleting the item.
Choose an object of the specified type to
edit.
There was an error editing the item.
Refer to the error message text.
No specified terminations are selected.
CTC could not edit the specified
termination.
Refer to the error message text.
The authentication key cannot exceed the
specified number of characters.
Refer to the error message text.
CTC encountered an error while creating
the area virtual link.
CTC encountered an error creating the
virtual link.
CTC encountered an error while setting the
area range for the specified values.
number.
Refer to the error message text.
4-21