Cisco ONS 15454 Troubleshooting Manual page 25

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-3228 The {0} termination(s) could not be created.
{1}
EID-3229 RIP is active on the LAN. Please disable RIP before enabling
OSPF.
EID-3230 OSPF is active on the LAN. Please disable OSPF before
enabling RIP.
EID-3231 An error occurred while setting the OPR.
WID-3232 The port state cannot be indirectly transitioned because the port
is still providing services.
If the port state should be changed, edit it directly through port
provisioning.
EID-3233 The current loopback provisioning does not allow this state
transition.
EID-3234 The current synchronization provisioning does not allow this
state transition.
EID-3235 The requested state transition cannot be performed on this
software version.
EID-3236 The database restore failed. {0}
EID-3237 The database backup failed. {0}
EID-3238 The send PDIP setting on {0} is inconsistent with the setting on
the control node {1}.
EID-3239 The overhead termination is invalid
EID-3240 The maximum number of overhead terminations has been
exceeded.
EID-3241 The {0} termination port is in use.
EID-3242 An {1} exists on the selected ports.
Therefore, you must create the {0}s one by one.
WID-3243 The port you have chosen as an {0} endpoint already supports
an {1}. The port cannot support both DCCs. After the {0} is
created, verify that no EOC alarms are present and then delete
the {1} to complete the downgrade.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the error message text.
Turn off the Routing Information Protocol
(RIP) on the LAN, before enabling OSPF.
Turn off the OSPF on the LAN before
enabling RIP.
An error was encountered while attempting
to provision the optical power received
(OPR).
Edit the port state while provisioning the
port.
Refer to the error message text.
You cannot transition the port state to the
target date while in the current
synchronization state.
Refer to the error message text.
CTC failed to restore the specified
database.
CTC failed to backup the specified
database.
The send payload defect indicator path
(PDI-P) setting on the specified item should
be consistent with that of the specified
control node.
Refer to the error message text.
Overhead terminations have exceeded the
limit.
The specified termination port is in use.
Select another port.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The same port can not be used by multiple
DCCs.
4-25