Cisco ONS 15454 Troubleshooting Manual page 12

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-2161 The sibling roll is not complete.
{0}
EID-2162 An error occurred during roll acknowledgement.
{0}
EID-2163 The roll cannot be canceled.
{0}
EID-2164 An error occurred during the roll.
{0}
WID-2165 The MAC address of the node {0} has been changed. All
circuits originating from or dropping at this node will need to
be repaired.
WID-2166 The node cannot be inserted into the domain because it is not
initialized.
WID-2167 You have insufficient security privileges to perform this action. You do not have the privilege to perform
WID-2168 The following warnings surfaced while loading {0}.
{1}
WID-2169 One or more of the profiles selected do not exist on one or more
of the nodes selected.
WID-2170 The profile list on node {0} is full. Please delete one or more
profiles if you wish to add the profile.
{1}
WID-2171 You have been logged out. Click OK to exit CTC.
WID-2172 The CTC CORBA (IIOP) listener port setting of {0} will be
applied on the next CTC restart.
EID-2173 The port is unavailable.
The desired CTC CORBA ({0}) listener port, {1}, is already in
use or you do not have permission to listen on it. Please select
an alternate port.
EID-2174 An invalid number was entered. Please check it and try again.
WID-2175 An extension byte mismatch occurred.
{0}
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-12
Chapter 4
Description
One of the rolls is not completed for the
dual roll. If it is auto roll, it will be
completed when a valid signal is detected.
If it is a manual roll, you must complete the
roll from CTC if Bridge and Roll is
operated from CTC, or from TL1 if Bridge
and Roll is operated from TL1.
Refer to the error message text.
CTC cannot cancel the roll.
CTC encountered a roll error.
Repair the circuits that originate from or
drop at the specified node, with the new
MAC address.
Initialize the node and proceed.
this action.
CTC encountered warnings while loading
the alarm profile import file.
The profile selected does not exist on the
node. Select another profile.
The number of profile that can exist on a
node has reached the limit. To add a profile,
delete any of the existing profiles.
Refer to the warning message text.
The Internet Inter-ORB Protocol (IIOP)
listener port setting for the CTC Common
Object Request Broker Architecture
(CORBA) will be applied on the next CTC
restart.
Select an alternate port, as the current port
is either in use or you do not have enough
permission on it.
You entered an invalid firewall port number.
Try again.
There is a mismatch with the extension
byte.
Error Messages
78-19418-01