Cisco ONS 15454 Troubleshooting Manual page 36

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-5016 An error occurred while attempting to provision the {0}.
{1}
EID-5017 Provisioning could not be rolled back. The {0} might be left in
an INCOMPLETE state and should be manually removed.
EID-5018 {0} is a(n) {1} node and cannot be added to a(n) {2} network. You cannot add the node {0} of type {1} to
EID-5019 The manual path trace mode for this equipment does not
support an expected string consisting of all null characters.
Please change the expected string or the path trace mode.
EID-5020 Software activation is in progress. Provisioning is not allowed. Refer to the warning message text.
EID-5021 Software activation is in progress. {0} is not allowed.
WID-5022 Warning: Ethergroup circuits are stateless (that is, always in
service).
The current state selection of {0} will be ignored.
EID-5023 CTC cannot communicate with the node.
The operation failed.
EID-5024 The overhead circuit will not be upgraded.
WID-5025 The path targeted for this switch request is already active. The
switch request can be applied, but traffic will not switch at this
time.
EID-5026 An ONS 15600 cannot serve as the primary or secondary node
in a four-fiber {0} circuit. Please change your ring and/or node
selections so that an ONS 15600 is not chosen as the primary or
secondary node in this four-fiber {1} circuit.
WID-5027 The {0} Edit dialog box for the ring {1} has been closed due to
significant provisioning changes. These changes might only be
transitory, so you can reopen the {0} Edit dialog box to view the
updated state.
WID-5028 Warning: This operation should only be used to clean up rolls
that are stuck. It might also affect completeness of the circuit.
Is it OK to continue with the deletion?
EID-5029 A software downgrade cannot be performed to the selected
version while an SSXC card is inserted in this shelf. Please
follow the steps to replace the SSXC with a CXC card before
continuing the software downgrade.
EID-5030 A software downgrade cannot be performed at the present time. Try the software downgrade later.
WID-5031 Canceling a software upgrade during a standby TSC clock
acquisition might result in a traffic outage.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-36
Chapter 4
Description
CTC encountered an error while
provisioning the card.
You may have to remove the MS-SPRing
manually as it was left incomplete.
the host node of type {2}. This prevents you
from hosting both SONET and SDH nodes
in the same session.
The path trace mode does not support
strings that consist of null characters. You
must either change the expected string or
the path trace mode.
Refer to the error message text.
Refer to the warning message text.
CTC encountered a network
communication error. Connectivity between
CTC and the NE was disrupted, either
transiently or permanently.
Refer to the error message text.
Refer to the warning message text.
Refer to the error message text.
Re-open the MS-SPRing edit window to
view the updated state of the ring.
Refer to the warning message text.
Refer to the error message text.
Refer to the warning message text.
Error Messages
78-19418-01