Cisco ONS 15454 Troubleshooting Manual page 53

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
WID-6204 This action will cause the node to reboot. When provisioning in
single-shelf mode, Shelf {0} of the node that you connect to
must be properly preprovisioned or you will lose traffic.
Use the LCD to return to single-shelf mode. CTC cannot be
used for this.
Changing from subtended shelf mode to single-shelf mode
could be traffic-affecting.
EID-6205 The interlink port is not provisioned.
EID-6206 The ADM peer group has already been created on the peer card. The user creates an ADM peer group
EID-6207 This card is not in the ADM peer group.
EID-6208 The payload is not OTU2.
EID-6209 The side is already defined by the node.
EID-6210 No side was selected.
EID-6211 The side was not deleted.
EID-6212 One of the ports is connected to a patchcord or virtual link.
EID-6213 It is not possible to associate the side to the two ports.
EID-6214 The port is already assigned to a side.
EID-6215 Error provisioning the CVLAN ID.
Enter a valid number or range between 0 and 4094.
EID-6216 Changing card will reset the optical thresholds to the default
setting and may affect the optical connection.
The optical connection will work only if the optical
performance is compatible with {0} card.
Please check the network design.
EID-6217 You cannot delete the {0} {1}.
EID-6218 Invalid ethernet duplex value
EID-6219 Invalid committed info rate
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Refer to the warning message text.
The user creates an ADM peer group
without interlink ports.
involving an ADM card inserted in a peer
group.
The selected ADM card is not involved in
an ADM peer group.
Refer to the error message text.
During the creation of a side on node, a side
is already defined.
The user requests an operation on a side, but
no side is selected.
CTC could not delete the selected side
successfully.
An operation on a port was not performed
because the port is connected to a patchcord
or a virtual link.
During the creation of a side it is not
possible to associate the selected ports to
the new side.
The selected port is already assigned to a
side.
The entered CVLAN ID was out of the
admitted range.
Refer to the error message text.
You cannot delete {0} {1} because it is part
of an ADM peer group or one or more
circuits are provisioned on it.
the Ethernet duplex value is invalid. Enter
again.
The committed info rate value is invalid.
Enter again.
4-53