Cisco ONS 15454 Troubleshooting Manual page 38

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-5049 Provisionable patchcords created between gray STM-N trunk
ports and multiplexer/demultiplexer ports are not supported.
EID-5050 The element model could not be found.
{0}
WID-5051 The port state cannot be indirectly transitioned because the port
aggregates OCHCC circuits: if the port state needs to be
changed, edit it directly through port provisioning.
EID-5052 The operation is not valid for the connection type.
EID-5053 The operation cannot be performed because the connection is
under test access.
EID-5054 The TL1 tunnel could not be opened. {0}
EID-5055 Some patchcords were not deleted. Patchcords cannot be
deleted if they are incomplete or support any circuits, or if the
nodes supporting them are not connected.
EID-5056 This PPC cannot be deleted because one or more circuits are
provisioned over it.
EID-5057 The addition of the last node has not yet finished.
Please wait before trying to add a new node.
EID-5058 An OCHNC upgrade is applicable only to bidirectional circuits. Refer to the error message text.
EID-5059 The OCHNC upgrade failed.
One or more communication failures occurred during the
operation.
EID-5060 The OCHNC upgrade partially failed.
One or more communication failures occurred during the
operation.
Create the OCHCC manually.
EID-5061 The overhead circuit source and destination must reside on the
same shelf.
EID-5062 A four-fiber {0} cannot be created using three cards.
WID-5063 The profile "{0}" includes a change to the OPEN-SLOT alarm
severity.
This change is disallowed for the ONS 15600. "{1}" will
continue to use the OPEN-SLOT severity of MN that is
included in the default configuration.
Other changes from the "{2}" profile were successfully applied
to {3}".
EID-5064 {0}
{1}
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-38
Chapter 4
Description
Refer to the error message text.
The specified Element Model cannot be
located.
Refer to the warning message text.
You may have selected the incorrect switch.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Remove the circuits provisioned over the
provisionable patchcord before trying to
delete it.
Refer to the error message text.
CTC encountered a complete failure while
upgrading optical channel network
connection.
CTC encountered a partial failure while
upgrading an optical channel network
connection.
Refer to the error message text.
A four-fiber MS-SPRing needs four cards.
Refer to the warning message text.
This indicates the status of path protection
switching.
Error Messages
78-19418-01