Cisco ONS 15454 Troubleshooting Manual page 43

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-5145 Unable to launch view for {0}
EID-5146 Unknown Error occurred while updating the SRLG value on the
Node/Link.
{0}
WID-5147 Are you sure you want to reset the additional SRLG for
{0}
EID-5148 Unable to set the SRLG for CRS node
{0}
EID-5149 Unable to get the node model
EID-5150 Unable to get the side model
EID-5151 Unable to delete the SRLG for CRS node
{0}
WID-5152 Some SRLGs cannot be synchronized.
Network operation might be inconsistent.
EID-5153 Unable to perform SRLG synchronization operation.
EID-5154 Specified value is out of range for SRLG.
SRLG value should be specified between {0}-{1}
WID-5155 No. of SRLGs for circuit {0} are exceeding the limit.
One circuit can have maximum {1} SRLGs defined.
Trimming SRLG list to defined maximum size.
EID-5156 Maximum limit for defining additional SRLGs for Node/Link
is reached. Maximum SRLGs that can be defined are {0}
WID-5157 No CRS based OCH Trail circuits detected
WID-5158 Some SRLGs cannot be deleted from CRS.
Please use Synchronize IPoDWDM to synchronize SRLGs.
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
The node/link is down.
Refer to the error message text.
Refer to the error message text.
• Cisco CRS node connectivity is down.
• XML interface on the Cisco CRS is not
reachable.
• Not enough memory on the Cisco CRS.
Complete node information could not be
retrieved.
Complete side information could not be
retrieved.
Refer to the error message text.
Refer to the error message text.
The node name/node IP address or link
•
source/link destination information
could not be retrieved.
Cisco CRS node connectivity is down.
•
XML interface on the Cisco CRS is not
•
reachable.
Not enough memory on the Cisco CRS.
•
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There are no Cisco CRS nodes associated
with the circuit.
Cisco CRS node connectivity is down.
•
XML interface on the Cisco CRS is not
•
reachable.
Not enough memory on the Cisco CRS.
•
4-43